Tennis Support

Properly Mounting the Zepp Sensor

Last Updated -

Flex Mount

Start by aligning the octagon shape of the mount with the octagon shape of your tennis racket handle. Stretch the mount over the bottom of the handle so the shapes are aligned, and pull the mount tight over the handle. To insert the sensor, find the Zepp logo and the two small protruding vertical tabs on two of the corners of the mount near the logo area. Align the sensor button with one of these tabs (either one) and insert the sensor into the mount with LEDs facing outward.  
 



If you find that the flex mount is uncomfortable, we recommend placing a piece of over-grip over the mount as shown below

Pro Mount

Start by aligning the octagon shape of the mount with the octagon shape of your tennis racket handle. Remove the tape from the bottom of the mount and press firmly to apply. Allow 24 hours for adhesive to set prior to use. To insert the sensor, align the LED channel with the logo on the mount and insert the sensor into the mount with LEDs facing outward. 
 

Did you find this article helpful?

Contact Us

Hours of operation are Monday - Friday 8:00am - 5:00pm PST